![]() Rotate the handlebar to check that it can move freely and that there is enough cable slack. Check that all cables are out of the way of moving parts.Secure any loose cables with zip ties, and trim them to be flush and smooth.At the top of the downtube, gently pull the wiring harness cable out while feeding more cable into the lower cable opening to create cable slack.Plug in all remaining connectors by finding the matching connector ends, lining up the internal notch and pins, and pressing together without twisting.Reinstall the grommet starting at the top or bottom of the opening, then gently working it around the opening until it’s fully seated.Double-check that the wiring harness connector is fully secure, then pass the connector into the lower cable opening.Plug in the wiring harness connector by finding the matching connector end, lining up the internal notch and pins, and pressing together without twisting.Pass the wiring harness connector through the grommet.Tighten the bolts one half-turn at a time, moving in an “X” pattern, until tightened securely.Place a mounting bracket in position and thread in the bolts by hand.Pass the cables in between the chainstays. Place the new controller on the frame as shown, so the side with more cables points downward.Remove the old controller and recycle it according to local rules.Ĭontinue to the next section to install the new controller.Shop our assortment of replacement parts. Our electric bikes have won more awards than any other brand from Electric Bike Review. Buy More, Save More: Save up to 350 on ebikes & accessories thru 9/12. Set the four bolts and two mounting brackets aside. Check out Rad ebikes now Skip to content. Use a Phillips head screwdriver to remove the four controller mounting bolts. Repeat until all connectors are unplugged from the controller. Unplug all connectors from the controller by pulling each connector directly apart, without twisting. Unplug the cables connected to the controller.We also carry Seats, Seat Posts, Waterbottle Holders, Locks, MTX Bags, Air Pumps, etc. Unplug the connector by pulling directly apart without twisting. Check out our Rad Power Bike accessories - Fender Kits, Metal Fender Kits, cables, brackets, batteries, charges, trailer hitch mounts and more for the 2017, 2018, 2019 RAD Rover, RAD-Mini and Mini Step-Thru, Rad Runner and other models.Be careful not to pull so hard that the connector unplugs inside the downtube. We want your bike to be as unique as you are This means you can personalize or customize your bike as you see fit. Turn the handlebar to the rider’s right side and gently feed some of the wiring harness cable into the top of the downtube while gently pulling the wiring harness cable at the bottom of the downtube until the connector moves out of the frame.Be careful to not damage the grommet, cables, or frame. Snip zip ties securing the cables at the bottom of the downtube, then use a flat head screwdriver and gentle pinching movements to carefully unseat the rubber grommet.Unplug the wiring harness connector, which is located inside of the downtube. ![]() Turn off the bike, remove the battery, and press and hold MODE to discharge remaining power.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |